[Thread Prev] [Thread Next]
Hi again,
About:
when I use
tto [t1 t2 t3] clickon
in the attached procedure I do get an error message.
Don't you all?
(I'm using MicroWorlds Pro. I did notice that MW EX
does not produce the error message).
Answer:
I've just tried this exact instruction in MWPro Windows.
Runs without a glitch.
Alain
-----Original Message-----
From: mwforum-admin@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
[mailto:mwforum-admin@xxxxxxxxxxxxxxxxxxxxxxxxxxxx]On Behalf Of Daniel
Ajoy
Sent: December 15, 2006 11:15 AM
To: Mwforum@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
Subject: RE: A way to exit the project by a procedure
On 15 Dec 2006 at 9:53, Alain Tougas wrote:
> Hum!
> I´ve just tried
> tto [t1 t2 t3 t4 t5 t6 t7 t8 t9 t10 t11 t12 t13 t14 t15 t16 t17 t18 t19
t20 t21 t22 t23 t24 t25 t26 t27 t28 t29 t30 t31 t32] fd 50
> in MW Pro and it works fine. Try
> get "page1 "turtles (using whatever is your page name)
> and look at the list of turtles on that page. If a single turtle from the
list is missing on the current page, you will get this error message.
> In other words... in MW Pro,
> tto does accept a list of turtles as input
> there must be a limit, but I tried 55 turtles and it was still fine.
No, I'm not talking about
tto [t1 t2 t3] fd 50
I'm talking about
tto [t1 t2 t3] clickon
Previous by thread:
RE: A way to exit the project by a procedure
Next by thread:
RE: A way to exit the project by a procedure
To save an attachment to your computer, PC users should right-click (Mac users, click and hold the mouse button) on the link and then choose 'save target as' from the pop-up menu. A window will then pop up in which you can choose a location for the file.
|
